PARTNER WEBINAR | Digital Engineering Basics – Product Model Trade Studies (Part 2) | ZUKEN Americas, Phoenix Integration & Vitech Corp
Phoenix Integration is proud to participate with Zuken and Vitech in the “Digital Engineering Basics” Virtual Event Series, hosted by Zuken.
As Digital Engineering continues to gain momentum, there are a lot of questions about how to create a product model and the associated design process. Companies are struggling with the model transition to detailed design and model relevancy throughout the product lifecycle. Zuken is presenting a three-part webinar series exploring the Digital Engineering Basics of product model creation using MBSE, the use of trade studies, and implementing a wire harness. The webinars are built upon a real-world video drone design.
Once you have registered for this webinar, you can register for Parts 1 and 3 here:
- Digital Engineering Basics – Building the MBSE Product Model (Part 1)
- Digital Engineering Basics – MBSE to Wire Harness Design (Part 3)
Abstract:
As Digital Engineering continues to gain momentum, there are a lot of questions about how to create a product model and the associated design process. Companies are struggling with the model transition to detailed design and model relevancy throughout the product lifecycle. Zuken is presenting a three-part webinar series exploring the Digital Engineering development process utilizing a video drone example. Part 1 covers a systems engineering approach to model creation. Part 2 will demonstrate how trade studies are performed on the product model to verify and optimize the architecture. Part 3 moves the drone model into the detailed design for wire harness implementation.
This webinar will demonstrate systems engineering best practices in verifying product requirements using a MBSE model. Parameters and Constraint definitions will be used to build equations to analyze various aspects of the model that lead to a business value trade-off. A critical product requirement is the operational time. Various aspects of the design will be analyzed to determine the system’s ability to meet that requirement. The ability to meet that requirement along with weight, cost, and video performance will be rolled up into business value analysis. The analysis will be run through ModelCenter® and integrate various analysis tools.
In this webinar, you’ll learn:
- Modeling Parameters and Constraint Definitions
- Delivering content to ModelCenter®
- ModelCenter® Analysis
- Receiving results from ModelCenter®
- Creating Verification Status Reports
Who should attend:
System Engineers, Senior Engineers, Project Managers, Electrical Engineers, Architecture Engineers, Engineering Managers
Watch the full webinar Duration: 1hr By registering and viewing this event recording, you agree to allow Phoenix to utilize your personal data as per our Privacy Statement, (https://www.phoenix-int.com/privacy-policy/), and for Phoenix to share your personal data with Vitech Corp and ZUKEN USA, our co-hosts for this event.